Data Communications

            Wireless RS485/422 RC36 It This device is used to transmit RS485/422 signals via radio waves, reducing installation costs by eliminating the need for signal cabling.

            Wireless RS232/485/422 RC35 This device is used to transmit RS232/485/422 signals via radio waves, reducing installation costs by eliminating the need for signal cabling.

            Radio Modem RC46 Radio Modem RC46 It is a wireless system designed to replace wired RS232 and RS485/422 systems, eliminating wiring complexities and simplifying installation.

            USB Isolator RC43 This device is designed to protect against electrical leakage or signal interference traveling from a computer to connected peripherals via the USB port-issues that could pose a danger to users. The RC43A electrically isolates the computer from the connected USB device, allowing only data to pass through.

            USB to RS-232 Converter RC27 Provides USB Port (Universal Serial Bus) that convert to RS-232 that done not require PCI/ISA slots or IRQS. Simply plug the converter into an available USB port on your computer or hub. Windows will configure the converter as an additional COM Port, compatible with your Windows applications.USB bus supplies power, so no separated power supply is needed.

            RS-232 Optical Isolator RP22 is designed for isolates and protects RS-232 Equipment from lightning surges, accidental high-voltage short, and ground loop. RS-232 data signals TD, RD, RTS, and CTS are supported at up to 115.2 kbps. The RP22 provides 2500 V RMS of isolation between sides.

            Typical DTE devices include PCS, terminals, and printers. Typical DCE devices include modems and multiplexers. Most computer DTE ports are male and most DCE ports are female. If the RP22 inserted into a working system, it will only pass signals if inserted correctly. Therefore, if devices communicate with each other without the RP22 in the line, but not after it is installed, simply reverse the isolator using gender and reinstall.

            RS485 Repeater RP24 is designed as a robust repeater for industrial applications where galvanic isolation is important. It can be used to extend both the distance and number of nodes on RS485 (2-Wire) network. Galvanic Isolation helps eliminate noise and protects equipment from destructive transients found in industrial application.

            RS-485/RS-422 Repeater RP23 is designed as a robust repeater for industrial applications where galvanic isolation is important. It can be used to extend both the distance and number of nodes on RS-485 (2-Wire) and RS-422 (4-Wire) network. Galvanic Isolation helps eliminate noise and protects equipment from destructive transients found in industrial application.

            RS-232 to RS-485/RS-422 Converter RC23 optically isolates and converts unbalanced, Full/Half-Duplex RS-232 signals to optically isolated, balanced, Full/Half-Duplex RS-422 or RS-485 signal at baud rate up to 115.2 kbps. This unit also surge suppress the RS-422/RS-485 lines. Features send data control circuitry so no software control of handshake lines is required in RS-485 Mode.

            USB to RS-232/RS-485 Converter RC22 Provides USB Port (Universal Serial Bus) that convert to isolated RS-232 and RS-485 that done not require PCI/ISA slots or IRQS. Simply plug the converter into an available USB port on your computer or hub. Windows will configure the converter as an additional COM Port, compatible with your Windows applications.

            A pair of LEDs show when data is being received or transmitted. USB bus supplies power, so no separated power supply is needed. 2000 VAC of isolation.