RDIO2100: Remote Wireless Switch

- Control 8 Digital Input / Output

- Long Distance 700 m.

- No Wiring (RF Link)

            Remote Wireless Switch RDIO2100 is remote wireless switch. It use for ON/OFF electronic device for long distance. RDIO2000 is radio frequency device so it is cost saving and No need for wiring

            When digital input of first RDIO2000 is “ON” then digital output of the second RDIO2000 is “ON”. Di1 of RDIO2000 (1) is “ON” then Do1 of RDIO2000 (2) is “NO”.

Show the Working Status of the Machine Through PL2000.

Remote Motor Control Application (4 Sets Max.)

            NOTE: When turn on device Power LED is “on” and RDIO2100 start to connecting to its pair. Connecting status indicate by LED light, Quickly blink is mean “connected” and slowly blink is mean “connecting fail”

DIP Switch 1 Last Status Mode
OFF Digital Output OFF
ON Hold Digital Output

            There are 2 required setting

  1. Status of DO when is no connecting
     
  2. Delay time for time out, if there is no response until delay time is run out RDIO2100
    will show connecting error. For example. If time delay time for time out is set at 5 seconds, after sending connection it will wait or 5 seconds if there is no response within 5 seconds error is occur. Table below is show dip switch for setting delay time
Delay Time (Sec.) DIP Switch 4 DIP Switch 3 DIP Switch 2
5 OFF OFF OFF
10 OFF OFF ON
15 OFF ON OFF
20 OFF ON ON
25 ON OFF OFF
30 ON OFF ON
35 ON ON OFF
40 ON ON ON

            Table below is show dip switch for setting amount of repeater in the network

Dip Switch จำนวน Repeater
6 7 8
OFF OFF OFF 1
ON OFF OFF 2
OFF ON OFF 3
ON ON OFF 4
OFF OFF ON 5
ON OFF ON 6
OFF ON ON 7
ON ON ON 8

*** in case of no repeater Dip switch 6, 7 and 8 should be set at OFF position

Specifications

Wireless Interface

Frequency Band:

2.4 GHz

RX Sensitivity:

(-)102 dBm

TX Power:

(+)10 dBm (Max)

Transmission Distance:

Up to 90 m. Indoor/Urban

Up to 700 m. Outdoor RF line-of-sight (With Antenna gain>8dBi)

Antenna Connector:

RP-SMA, Jack/Female

Digital Input

Digital Channel:

8 Channels

Sensor Type:

Wet Contact or Dry Contact

Wet Contact (DI to COM):

ON: 12 to 24 VDC

OFF: 0 VDC

Dry Contact (DI to GND):

ON: Short to GND

OFF: Open

Isolation:

Opto Isolated

Relay Output

Digital Channel:

8 Channels

Relay Type:

N.O.

Contact Rating:

5 A @ 250 VAC

5 A @ 30 VDC

Power Requirements

Power Supply:

85 to 230 VAC

12 to 35 VDC (Optional)

Environmental Limits

Operating Temperature:

0 to 55 °C

Operating Humidity:

5 to 95 %RH

Storage Temperature:

0 to 70 °C

Physical Characteristics

Dimension:

W160 x H90 x D60 mm

Mounting:

DIN Rail

Warranty

Warranty Period:

5 Year

Ordering
Ordering Information: Specify Power Supply
Example RDIO2100/220VAC
Packagelist

Package Checklist

1. RDIO2100

Downloads